Fiber Optic Sight set for the Taurus G3 w/o factory steel sights, G2C, G2S, PT111 G2, PT140 G2, PT709, PT740, and TX22

Fiber Optic sight set (front and rear) for your Taurus G3 w/o factory steel sights, G2C, G2S, PT111 G2, PT140 G2, PT709, PT740, and TX22. The sights come with 3 fiber optic rods in green, red and orange so you can use any combination of color that you prefer. They are machined from tough aircraft grade Aluminum Alloy and hard anodized and provide outstanding contrast in daylight.

 

With a flat surface on the front of the rear sight, these sights allow one-handed charging of the pistol action.

 

They are both held in with screws and no sight pusher is used in the installation.  The tools needed include drivers to remove the existing sights, a small Phillips head screw driver, thread locker, nail clippers or a side cutter, and a lighter to install the fibers into the sights.  Expect minor fitting  of both sights to be required (For example- filing using needle files or similar) because they are made to the largest dovetail size so a tight fit can be had on any pistol.  Yes, dovetails vary.

 

The sight set comes with new screws for the front sight and rear sights.  The rear sight is adjustable for windage when mounting.

 

Front screw - M2.5 X .45 X 3            Rear screw - M2.5 X .45 X 4

 

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.